In the condensing industrial boiler suppliers market, oil and gas boilers, coal-fired boilers, and biomass boilers occupy almost the entire market. Among them, many countries and regions have demanded the use of clean boilers because of their emphasis on environmental protection, which has also promoted the development of environmentally friendly oil and gas boiler manufacturers.

The Hulun Buir City, Inner Mongolia, due to its special geographical location, well into the cold season, heating condensing industrial boiler supplierss put into use. Safe use of district heating boiler equipment, Hulunbeir special inspection carried out the inspection work to ensure the operation of heating boilers for the Evenki Autonomous Banner Dayan Town, tie Nihe mine, Bayan hematoxylin lofty Kong and other regions.

Inspectors checked one by one aspect of the boiler, safety accessories, ancillary equipment, water quality management and data review and so on; and the verification process in all corporate communications using the boiler should pay attention to regulatory knowledge and safety knowledge, urged business executives to issue timely corrective to ensure the safe use of heating boilers.

6 tons adjusting a combustion gas steam condensing industrial boiler suppliers, normal combustion boiler three basic aspects of indicators include a uniform supply of the fuel, reasonable ventilation, adjustment the combustion. 1, to maintain the high temperature of the combustion chamber temperature of the upper layer is preferably in the 1100 ~ 1300 ℃, flame orange in color. Flame reddish color indicates that the amount is not enough to the wind, the color white indicates that excessive wind. It should be appropriately adjusted. 2, fuel ash to reduce ash content in the combustibles to be below 10%. 3, reducing the temperature of the boiler flue gas exhaust gas temperature should be controlled below 200 ℃. 4, holding furnace negative excess air boiler is 1.2 to 1.4, by adjusting the balance of the blowers to maintain the furnace pressure is -20 ~ -30Pa. 5, the thermal efficiency of the boiler to improve the thermal efficiency of the boiler should be kept above 60%. II. Combustion Adjustment 1, the amount of fuel to air required for combustion and the amount of a reasonable distribution. Ventilation should first increase the amount of fuel increases, it should first reduce the amount of fuel supply reduced ventilation. 2, the thickness of the seam and seam thickness configuration grate speed is 80 ~ 120mm grate speed at high, middle and low profile configuration of several commonly used methods:. 9a rapid combustion of thin seam b c thick seam in low combustion. 3 thick seam combustion speed, the segment with the wind blowing principle: burn promoting intermediate ends. That is, after the coal into the coal starts to warm up the shutter, fire line front arch, the primary combustion zone, the middle grate to burn the rear grate zone. Normal combustion conditions are: fuel from the coal at the beginning of the fire shutter 300mm, uniform flames, the fire bed formation, at the end of combustion from the end of the grate 300 ~ 500mm. 4. maintain proper furnace temperature to avoid coking. The fire bed to maintain the homogeneous combustion, to avoid burning fire bed obliquely. 6. The residence time of the fuel on the grate in less than 30 minutes.

Coal plant for power station

Natural gas conversions on power plant boilers