If the gas hot water bridge control of steam turbines with associated boilers plumbing system had not using antifreeze, the antifreeze before joining Flush plumbing system.

How Does it Work?

Conventional coal plants use pulverized coal, ground to the consistency of facial powder, and burn it at temperatures between 2,200 F to 2,400 F. In contrast, CFBs use coal in chunks about 3/8-inch in size mixed with limestone and burn it at lower temperatures—1,500 F to 1,650 F. Air is blown into the boiler to suspend, or fluidize, the mixture. Heat in the boiler converts the limestone to lime that absorbs SO2, removing most of it in the furnace.

Inside the Fangkuai bridge control of steam turbines with associated boilers plant, there is a special corrugated furnace bladder production line, which can be processed according to the computer setting mode. At the same time, this is also a unique processing technology of Fangkuai Boiler. The cost of natural gas fuel alone exceeds 5 million yuan per year. The corrugated furnace liner fired by this production line can not only increase the heating surface of the boiler, but also alleviate the damage caused by the thermal expansion and contraction to the combustion chamber, and greatly extend the service life of the boiler.

The key step to pay attention to when installing the hot water bridge control of steam turbines with associated boilers is the selection of the installation place of the hot water boiler: the boiler should be installed in a reasonable position, select the place where the air circulation space is large, do the floor well, and if necessary, make the foundation according to the foundation diagram. In order to avoid vibration in operation, to the boiler equipment damage. Installation choice: in order to ensure safe operation, please let the factory's staff be responsible for installation, they have professional knowledge, and installation experience. Or find a qualified installation company to install, which is the first condition to ensure the safe use of boilers. Third, check the gas source after installation: when the gas-fired hot water boiler is installed Well, in the case of ensuring that there is no clear fire nearby, open the gas valve to see if there is a gas leak phenomenon, if there is no gas leakage phenomenon will be installed, if there is a leak, it is necessary to check and solve the problem, so as to avoid accidents.